How To Size A Field Hockey Stick

  • Whatsapp
How To Size A Field Hockey Stick
How To Size A Field Hockey Stick

How To Size A Field Hockey Stick – I began pushing for the inclusion of the stick diagram in the published rules of hockey in 1990, and in 2000 the FIH Hockey Rules Council responded with (scanned from the 2000 rulebook):-

This made me angry. I kept complaining about this disgusting graphic but got nowhere, because the FIH doesn’t want to endorse a brand’s product (when the guys at the FIH are doing everything they can to ban it) I also suggested (half jokingly) that the direction of the curves is reversed without indicating which hockey stick is available ” permissible deviation” shows – and FIH HRB did exactly that in 2004 (next chart below). These two charts remained sticky charts for fifteen years despite repeated promises from 2005 that they would “see” (nothing) at a later date.

How To Size A Field Hockey Stick

How To Size A Field Hockey Stick

The part of the stick rule regarding dimension as written in 1990 and as it appears in the Rules of Hockey in 2003.

Osaka Field Hockey Stick Pro Tour Ltd

A. The length of the open bent end extending the rod in the positive X axis direction is 100 mm maximum (shown in line D).

B. A maximum of 20 mm from wand line(s) A and/or A1 (shown as lines B and B1 respectively)

C. Including any additional caps used, the wand must pass through a ring with an inner diameter of 51 mm.

2.4 The handle is allowed to be bent or bent so that it only once exceeds the line A to the specified line B max or shall not be bent or bent but only once beyond the line A1 to the specified line B1 max.

Best Field Hockey Sticks

I don’t know why this change happened, I believe it was a copying error in 2004, when all the technical specifications of the equipment were removed from the rules of hockey and published in a separate brochure. The equipment specifications were returned to the Rules of Hockey in 2006, and the error has been repeated in all rulebooks published since then. My repeated writings to the FIH HRB to rectify this have gotten nowhere.

Existing schematics do a very good job of masking the configuration and dimensions of the ridge ridges they are supposed to show. The bends shown in the diagram on the left go in the opposite direction to the bend pattern in my design because FIH is unwilling to endorse any particular brand with a range of allowable bends. The graph on the right is from a chart I submitted to the FIH HRB, but the dotted lines I included to show the overlap between the two heads shown (sample maximum rebound head and conventional hook) are not included, so the difference between conventional and extreme clearance is probably not clear. (The zigzag ambi, at about half of the allowed scaling, is nowhere near an extreme potential configuration – and is probably only useful in a goalie stick – see last diagram below).

Alternate diagram of face of stick face with pictorial description of allowable combinations of curves or ridges on stick handle edges and corrected rule text shown inside. This chart has been in the possession of the FIH Human Resources/Rules Committee for over ten years.

How To Size A Field Hockey Stick

I haven’t even seen the arc measure, only a schematic diagram of it and don’t know who owns it, so it’s hard to comment on it, it seems to be a very complex shape. Can be done with 25mm cylinder or tube. The only other equipment needed is a flat surface (an ironing board provides a suitable flat surface of an inclined angle, these tables are easy to carry and can be set up quickly), a small ruler or set square and a tape measure.

Carbon Content Teen & Adult Field Hockey Sticks — Hoek Hockey

When the former secretary of the FIH Rules Committee, Roger Webb, asked my opinion on the degree and position of the stick arc, I suggested a maximum of 25mm, anticipating the possibility of a so-called “low arc” and a safety issue. With accidental increased strokes, they should not be so that the position of the maximum arc is greater than 200 mm from the center of the stick length and within 150 mm.

The permissible arc is then 50 mm and there are initially no restrictions on the maximum arc position. When the maximum arc was very quickly reduced to 25mm, a low-profile stick appeared (and was heavily promoted as a flick-pull stick). The 25mm lower arc has given the stick face of the ball at the same angle at mid-point as a 50mm arced stick – so the position of the maximum bow on the stick is controlled and is now at least 200mm up from the handle to the base of the stick head, depending on the stick length 325mm from the center of the stick and 350mm centering: double what I suggested, but at least there are some provisions.

As modern composite cane heads do not have a handle attached, and even in wooden canes this is a measure of economy rather than necessity, and I later suggested that the difference between head and handle should be in the plane of the line with the maximum allowable flip. Up to the toe of the head, 100 mm from the ground or the base of the head of the stick – and not at the end of the V-joint as before. The proposal was readily accepted.

With respect to the stick diagram showing the burrs allowed on the edges of the stick – alternatively as above,

Gryphon Size Charts

About the arc (not the rake, a rake is the curve of the heel edge of the stick, not the face of the stick) – nothing, it’s too late now and the manufacturers should have known for years that there are strict limits.

Overlaid on the proposed schematic diagram is a representation of the zigzag ambi configuration. The ridges on the sides of the ambi rim shall be half of its permitted width.

When adjusting the maximum allowable protrusions, 20 mm was added to the width allowed by the specified diameter of the FIH stick ring, to allow for goalkeeping sticks that already existed at the time, which had a much lower edge than the grip. handle (it was unacceptable to ban sticks that had been on the market for many years at the time).

How To Size A Field Hockey Stick

The head of the stick, the part below the C-C line is not limited along the X-axis and protrudes more than 20 mm towards the heel as well as towards the toe, but such protrusion is a hindrance and not useful. In a stick intended for use by a fielding player. Ambi setback is determined by the degree of backlash possible before the player adjusts when playing push. Excessive bounce (maximum allowed) will cause the thrust to slip on the ground during the stroke and must be tuned for that.

Field Hockey Sticks

The slightly bouncy head achieved a better head shape than the previous very narrow heel curve, and by using lamination and adding torsion to the shaft above the toe, wood overcame the curve problems – this was when club design, in 1985 (and even 1992), was the only material from which a club head could be made. This is Twisting the shaft also improves stopping on the forehand and backhand sides, by greatly increasing the space provided above the ball on the forehand side and the horizontal space provided for the ball on the backhand side without the left hand having to land. This last feature improves the player’s balance when receiving as well as increasing the ability to clear play when receiving the ball in this position. The fact that it is no longer necessary to place the receiver’s head at the level of the opponent’s knees when performing a horizontal reverse stop has also improved the safety of players.

Player safety was considered a negative marketing point in the 1990s (and still isn’t), when hockey sticks were sold with the promise that they would generate more force through the ball so it would travel faster. Hitting the ball too fast is a matter of technique and has little to do with the configuration of the stick, after a certain point it is rarely considered.

Configuration shown

How to buy a field hockey stick, how to make a field hockey stick, how to regrip a field hockey stick, how to measure field hockey stick, what size field hockey stick, field hockey stick size chart, how to hold a field hockey stick, how to measure for field hockey stick, field hockey stick size guide, how to size a field hockey stick, size field hockey stick, how to choose a field hockey stick

Related posts